Wednesday, October 31, 2012

The Never-Ending Quest

That's the quest for a "perfect" t-shirt, naturally. Truly, I don't know if I get closer or farther from that objective the more I work at it.

Though I do like the Ottobre Basic Design t-shirt shown in my last post, it does pose a fitting problem that I have yet to solve. Even though the shirt overall seems to have sufficient ease and looks fine when I'm standing still, when I lift my arms, the bodice hikes up over my bust. When I lower my arms, the shirt stays put in the wrong location.

Another aspect of this "hiking up" problem is that the neckline also seems to pull a bit toward the bodice.

I have done the sort of minimal FBA that consists of drawing a bump at the side seams, which is then eased to the back. I have cut different sizes at the neck and shoulder area. I have added more room at the side seams generally. And I've made the top in a variety of fabrics. To a greater or lesser extent, all of these variations still yield the "t-shirt stuck above the bust" situation.

A lack of sufficient width must be a part of this problem, but it seems to me that something about the angle and/or length of the shoulder and the armhole is also not quite right.

Thus was the stage set for experimentation with Kwik Sew 3740.


This is an odd choice because, first, Kwik Sew patterns are generally cut extremely large in the upper chest for me and second, this pattern specifically had been tried last year and found guilty of this fault. On the other hand, it is much straighter than the Ottobre pattern, so I thought the comparison might be instructive.

The two views in the Kwik Sew pattern have the same neckline but different armscyes to accommodate sleeves or not. The sleeveless top has an armscye that curves back in and up toward the underarm, which I thought might eliminate some of the folds that I get at the armhole. Below you can see the difference. 

 

On the left is View A, the sleeved version, with various alterations. On the right is View B, with the sleeve from the Ottobre t-shirt. Much to apologize for here--hair, lack of makeup, wrinkles--but onward! Both of these are made from cotton interlock knit, bought in scant one yard pieces at a recent local warehouse sale. Many choices derived from fabric shortages.

What I see in these pics, and I'm open to different interpretations:

  • On the left there is pooling of the fabric above the bust which I think is a result of excess width across the chest at that point
  • On the right there is less pooling above the bust. A similar amount of width was removed from both View A and View B, but View A has a different shape at the armscye.
  • On the right, the shoulder width may be getting too narrow.
But in neither case does the shirt hike up above the bust and get stuck when I raise my arms.


May I just say that as much as I love wearing 100% organic cotton interlock, a little spandex would not go amiss in these tops?

Here are some shots of my alterations for View B. I hope you can see them.


On both the front and the back, I have drawn a line from the apex of the most prominent feature (bust in front, shoulder blade in back) to the lower third of the neck edge and then downwards, parallel to the center fold through the hem. I then slashed both lines, leaving a pivot point at the apex, and overlapped the neck edge by 1/2", spreading the lower edge the same amount. This alteration narrows the chest width and increases the circumference at the lower edge at the same time, both of which I need! If I didn't need the extra width at the hem, I could remove the corresponding amount at the side seam.

I've also filled in the neckline and raised it 1" at center front, but I need to add more for a round neckline.



From here I messed around with another scrap of fabric, a thin cottony sweater knit from Fabric Mart. I wanted to replicate Vogue 1261, which has been positively reviewed and made up into any number of adorable versions, but which is said to be very wide in the neck and shoulders. Looking at the photos, I can well believe it!


I should have and would have added more width at the lower edge, but I was very short on fabric. So my top is not as full at the hem as the pattern's. And my cowl is much narrower, so much so that's it's scarcely a cowl at all. But that was the maximum depth I could achieve with my fabric!



See how easy it was to turn this t-shirt into an approximation of the other pattern? I think this was a lot less work than purchasing and cutting out a whole new pattern.


Sure wish this knit had more body and didn't show every bump and strap and seam beneath it.


So it will probably be mostly worn beneath a long jacket, like my fabulous, aging Oilily sweater coat. I have had this coat for thirteen years and I love it more every year that passes. It is full of holes and I need to replace a button. I saw the same sweater on eBay recently, but sadly in XL. If I see one in my size, I will buy it without a second thought!




3 comments:

  1. Hi!
    Love to drop in for sewing inspiration; and I'm keeping an eye out for your final "Perfect T" discovery. (Then I might brave up enough to buy a pattern!)

    The best success I've had so far is making a knock-off from a favorite. However, that worked once perfectly, then failed miserably (though I think it was a cutting/layout error on my part.)

    One thing I learned, with those tops that are just a tad too light or clingy, and look fine from the front, but not the back, is to wear a tank top.
    This particular one is high necked in the back, and not too low or high in the front (so it can hide with some tops, or provide modesty for others) and it is made of thin slippery, very stretchy knit. Works great for smoothing lumps and bumps and giving the outer fabric something to glide over.

    Sorry I don't have a brand name, but I think you could find something like this in a sportwear/athletic department. =)

    I enjoy your posts and progress!
    Thanks for sharing!
    Em

    ReplyDelete
    Replies
    1. Hi again!
      I found the exact knit in JoAnn's as a swimwear lining. I'll have to make another sometime, with the neck and armholes bound in self-bias. It's so versatile! And adds a breathable layer of warmth for damp chilly days.

      Delete
  2. Hello...
    Just thought I'd drop a note saying I really love how you alter patterns and make them work for different ideas. Especially as my 'uniform' usually includes a tee, I'm liking this post a lot. However, I don't seem to understand how, where/the way you drew the lines you made to narrow the chest width. If it isn't too much of a bother could you explain it further or post a drawing indicating the lines created & cuts made??? Please?
    Thanks for putting your work out there & inspiring me to get on with my sewing. It is appreciated.
    T.

    ReplyDelete